{"product_id":"rfd868x-eu","title":"RFD868x-EU","description":"\u003cdiv class=\"card__header\"\u003e\n\u003ch2 class=\"card__title heading h3\"\u003eDescription\u003c\/h2\u003e\n\u003c\/div\u003e\n\u003cdiv class=\"card__section\"\u003e\n\u003cdiv class=\"rte text--pull\"\u003e\n\u003cp\u003e\u003cspan\u003e\u003cstrong\u003eMPN: MODEM-RFD868x-EU\u003c\/strong\u003e\u003c\/span\u003e\u003c\/p\u003e\n\u003cp\u003e\u003cstrong\u003e\u003cspan\u003eManufacturer: \u003c\/span\u003e\u003ca rel=\"noopener\" href=\"http:\/\/store.rfdesign.com.au\/\" aria-describedby=\"a11y-new-window-message\" target=\"_blank\"\u003eRFDesign\u003c\/a\u003e\u003c\/strong\u003e\u003c\/p\u003e\n\u003ch3\u003e\u003cspan\u003eProduct Description:\u003c\/span\u003e\u003c\/h3\u003e\n\u003cdiv class=\"ProductDescriptionContainer\"\u003e\n\u003cp\u003e\u003cspan\u003e\u003cstrong\u003ePlease note:\u003c\/strong\u003e\u003c\/span\u003e  The EU certified modems have limited operation modes, a low power (5mW) full duty cycle mode, and a high power (500mW) low duty cycle mode. The low power mode will significantly reduce the effective range of the system and the low duty cycle mode will significantly reduce data throughput. These conditions are a requirement of the certified modems and CANNOT be altered.\u003c\/p\u003e\n\u003ch3\u003e\u003cspan\u003eRFD868x-EU New Features:\u003c\/span\u003e\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli\u003eNew Processor, ARM 32-bit core.\u003c\/li\u003e\n\u003cli\u003eAir data rate: 200kbit\/s. \u003c\/li\u003e\n\u003cli\u003eAES Hardware accelerated encryption. *Fully working*\u003c\/li\u003e\n\u003cli\u003eRC PPM Passthrough with telemetry at the same time.\u003c\/li\u003e\n\u003cli\u003eFully ESD protected + filtered - Every IO port is protected and filtered.\u003c\/li\u003e\n\u003cli\u003eOriginal SiK point to point firmware implemented.\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003eNote: Currently due to the bandwidth limitations of the 868 modems Asynchronous Mesh and Multipoint Firmware are not officially supported for the 868X modems and correct operation of this code cannot be guaranteed\u003c\/span\u003e\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch3\u003eFeatures:\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli\u003eLong range \u0026gt;20km depending on antennas and GCS.\u003c\/li\u003e\n\u003cli\u003e2 x RP-SMA RF connectors, diversity switched.\u003c\/li\u003e\n\u003cli\u003e500mW (+27dBM) See specifications.\u003c\/li\u003e\n\u003cli\u003eTransmit low pass filter.\u003c\/li\u003e\n\u003cli\u003e\u0026gt; 20dB Low noise amplifier, high IP3.\u003c\/li\u003e\n\u003cli\u003eRX SAW filter.\u003c\/li\u003e\n\u003cli\u003eAll I\/O ESD protected and filtered.\u003c\/li\u003e\n\u003cli\u003eRe implemented SiK and firmware, field upgrade-able, easy to configure.\u003c\/li\u003e\n\u003cli\u003eSmall, lightweight.\u003c\/li\u003e\n\u003cli\u003eNote: Not compatible with older modems\u003c\/li\u003e\n\u003cli\u003eThe standard RFD868x will not communicate with the RFD868x-EU modem unless the standard RFD868x is configured to the same frequency as the EU modem.\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch3\u003e Interfaces:\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli\u003eRF: 2 x RP-SMA connectors\u003c\/li\u003e\n\u003cli\u003eSerial: Logic level TTL (+3.3v)\u003c\/li\u003e\n\u003cli\u003ePower: +5v, ~800mA max peak (at maximum transmit power)\u003c\/li\u003e\n\u003cli\u003eGPIO: 6 General purpose IO (Digital capable). \u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch3\u003eSpecifications:\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli\u003eFrequency Range:  868-869 MHz\u003c\/li\u003e\n\u003cli\u003eOutput Power: 500mW (+27dBm), controllable in 1dB steps (+\/- 1dB @=20dBm typical)\u003c\/li\u003e\n\u003cli\u003eAir Data transfer rates: 12, 56, 100, 200 kbit\/sec (User settable, 200 kbit default) *\u003c\/li\u003e\n\u003cli\u003eUART data transfer rates: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, 230400, 460800, 1M baud (User settable, 57600 default) *note these values are correct as of version 3.07 SiK firmware.\u003c\/li\u003e\n\u003cli\u003eOutput Power: 500mW (+27dBm)\u003c\/li\u003e\n\u003cli\u003eReceive Sensitivity: \u0026gt;111 dBm at 12 kbps, 105 at 64 kbps and 98 at 200 kbps.\u003c\/li\u003e\n\u003cli\u003eSize: 30 mm (wide) x 57 mm (long) x 12.8 mm (thick) - Including RF Shield, Heatsink and connector extremities\u003c\/li\u003e\n\u003cli\u003eWeight: 14.5g\u003c\/li\u003e\n\u003cli\u003eMounting: 3 x M2.5 screws, 3 x header pin solder points\u003c\/li\u003e\n\u003cli\u003ePower Supply: +5 V nominal, (+3.5 V min, +5.5 V max), ~800 mA peak at maximum power\u003c\/li\u003e\n\u003cli\u003eTemp. Range: -40 to +85 deg C, tested operational from -73 to +123 deg C.\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch3\u003eSoftware \/ GCS Support:\u003c\/h3\u003e\n\u003cp\u003eThe software solution is an open-source development called \"SiK\".  It has been re implemented to suit the new processor architecture available on the 32bit ARM processor core.  A boot loader and interface is available for further development and field upgrade of the modem firmware via the serial port.\u003c\/p\u003e\n\u003cp\u003eMost parameters are configurable via AT commands, Eg. baud rate (air\/uart), frequency band, power levels.\u003c\/p\u003e\n\u003cp\u003eIntegrated support for configuring the RFD radios is supported by APM Planner.\u003c\/p\u003e\n\u003cp\u003eThe default settings are at 57600 baud, N, 8, 1, and 200k air data rate.\u003c\/p\u003e\n\u003cp\u003eThe RFD868\/900x manual is here:\u003cspan\u003e \u003c\/span\u003e\u003ca href=\"http:\/\/files.rfdesign.com.au\/Files\/documents\/RFD900x%20DataSheet.pdf\" rel=\"noopener\" aria-describedby=\"a11y-new-window-message\" target=\"_blank\"\u003eRFD900x Manual\u003c\/a\u003e\u003c\/p\u003e\n\u003cp\u003eThe RFD868\/900x SiK software manual is here :\u003cspan\u003e \u003c\/span\u003e\u003ca href=\"http:\/\/files.rfdesign.com.au\/Files\/documents\/RFD900x%20Peer-to-peer%20V3.X%20User%20Manual%20V1.2.pdf\" rel=\"noopener\" aria-describedby=\"a11y-new-window-message\" target=\"_blank\"\u003eRFD900x Peer-to-peer Manual\u003c\/a\u003e\u003c\/p\u003e\n\u003ch3\u003e\u003cspan\u003e\u003cstrong\u003eSoftware features include:\u003c\/strong\u003e\u003c\/span\u003e\u003c\/h3\u003e\n\u003cul\u003e\n\u003cli\u003e\u003cspan\u003eFrequency hopping spread spectrum (FHSS)\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003eTransparent serial link\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003ePoint to Point\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003eConfiguration by simple AT commands for local radio, RT commands for remote radio\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003eUser configurable serial data rates and air datarates\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003eError correction routines, Mavlink protocol framing (user selectable)\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003eMavlink radio status reporting (Local RSSI, Remote RSSI, Local Noise, Remote Noise)\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003eAutomatic antenna diversity switching on a packet basis in realtime\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003eAutomatic duty cycle throttling based on radio temperature to avoid overheating. \u003c\/span\u003e\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch3\u003e\u003cspan\u003eCompliance:\u003c\/span\u003e\u003c\/h3\u003e\n\u003cp\u003e\u003cspan\u003eWe declare that the equipment is in conformity with the relevant Union harmonisation legislation:\u003c\/span\u003e\u003c\/p\u003e\n\u003cp\u003e\u003cspan\u003eDirective 2014\/53\/EU on radio equipment\u003c\/span\u003e\u003c\/p\u003e\n\u003cp\u003e\u003cspan\u003eThe RFD868x-EU is compliant with the following standards:\u003c\/span\u003e\u003c\/p\u003e\n\u003cul\u003e\n\u003cli\u003e\u003cspan\u003eEN300 220 V3.1.1\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003eEN301 489-3 V2.1.1\u003c\/span\u003e\u003c\/li\u003e\n\u003cli\u003e\u003cspan\u003eIEC 62368-1:2014\u003c\/span\u003e\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003c\/div\u003e\n\u003c\/div\u003e\n\u003c\/div\u003e","brand":"Anyuno ","offers":[{"title":"Default Title","offer_id":52389325766816,"sku":"MODEM-RFD868x-EU","price":1534.0,"currency_code":"ILS","in_stock":false}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0670\/9857\/5008\/files\/868x-eu_final__14611.1621220877.1280.1280.webp?v=1743955509","url":"https:\/\/www.anyuno.com\/en\/products\/rfd868x-eu","provider":"Anyuno ","version":"1.0","type":"link"}